Plugging requirements for cotton vehicles
01 before loading, for the door on one side that does not work, firstly block the gap between the two sides and the middle of the door (including both ends of the upper part of the door) from the inside of the vehicle with styrofoam and atomic ash, and then block the door and window with liner materials such as plastic cloth, and use adhesive tape to seal and paste, without any gap.
02 after packing the cotton bag, use plastic cloth to block the door pad, and use adhesive tape to stick tightly. Close the door, carefully check and confirm that there is no leakage of cotton bag. Seal the gap between the two sides and the middle of the door (including both ends of the upper part of the door) from the outside of the vehicle, using styrofoam, atomic ash, etc.
03 each cotton loading station shall focus on strengthening the blocking inspection of cotton vehicles, timely feedback information in case of any problem, and properly handle it according to the regulations.
Illustration of plugging
Before loading cotton, the carriage must be thoroughly cleaned
There shall be no inflammable sundries and metal powder left in the car
No oil stains on the floor
The window shall be blocked with plastic film and firmly pasted on the vehicle body with adhesive tape
Plastic cloth size ratio window
Size up to 5cm
The window shall be blocked with plastic cloth
Before loading, use styrofoam or atomic ash for the door on the side that does not carry out the operation to align the upper ends of the door from the inside of the vehicle
Seal the upper part of the door with styrofoam
Sealing the gap between the two sides and the middle
Block the inside of the front door with Styrofoam block the inside of the rear door with styrofoam
Block the middle part of the front door with Styrofoam block the middle part of the rear door with styrofoam
Then hang the plastic film at the door and stick it firmly on the vehicle body with adhesive tape
Plastic film hanging at the door
The plastic film is pasted on the car stickers with adhesive tape
The bottom seam of the door shall be sealed with sandbags. There shall be no hidden danger of sliding out of the door. The corrugated paper or the plastic cloth of the pad in the middle of the vehicle shall be turned up by 25-30cm against the door end. The sandbag for sealing the door shall be rolled into a whole with plastic film and placed on the corrugated paper or plastic cloth with pad, which shall be stuck in the gap. One end of the corrugated paper is turned up against the door
25—30cm
The sandbag is rolled into a whole with plastic film and placed on the corrugated paper
Plastic cloth at the door is placed on corrugated paper and sandbags
A layer of corrugated paper or plastic cloth with the liner unfolded step by step shall be padded while loading the vehicle. In case of any cotton bag break or flying flower leakage during loading, the break shall be repaired or pasted in time. It is forbidden to break the package into the vehicle. The cotton bag at the middle door of the vehicle shall not crush or collide with the door.
Status of cotton bag at the door after loading
After loading, use sandbags and plastic cloth to block the inner side of the door
After loading, the door shall be blocked with sandbags, and after loading, the door shall be blocked by hanging plastic cloth
Plastic cloth shall be firmly pasted on the door with adhesive tape
Hang plastic cloth firmly on the door frame with adhesive tape
After closing the door
From the outside of the vehicle, use styrofoam or atomic ash to align the upper ends and both sides of the door
Sealing the middle gap
Both sides of the exterior of the door are not blocked. The upper end of the exterior of the front door is blocked with Styrofoam
The outer side of the door is sealed with styrofoam, and the middle part of the door is sealed with Styrofoam
Guys, have you learned?
Mr. Zhang is always welcome to ask questions~
Financial media studio of Kuitun freight center
Source: Zhang Fengxia
Editor: Zhang Xu